rodntod

Active Member

• Dec 11, 2014

• #1

Evening all,
Can anybody tell me where i can get decent spill pipe,as the widely available 3.2mm ID stuff is just not snug enough .

Thanks in advance
Ed

 

brianp38dse

Well-Known Member

• Dec 11, 2014

• #2

I had that problem ended up useing small cable ties abit of a fiddle useing snipenose pliers and small screwdriver to tighten them on but worked, and i allready had the ties.

 

rodntod

Active Member

• Dec 11, 2014

• #3

Cheers,i'll give it a try

Ed

 

wammers

No longer with us, RIP

Donater

• Dec 11, 2014

• #4

Get proper 1/8" spill pipe from a motor factors and not the ****e off Ebay. The spill nipple cone is 4 mm in diameter proper spill pipe will never come off. If you remove spill pipes you MUST shorten them slightly to form a new seal area. As the seal area will be damaged on removal and the pipe will leak. Or fit new pipes.

 

P

pete1987RRC

Well-Known Member

• Dec 12, 2014

• #5

Any diesel specialist will have some

 

Dippypud

Never Knowingly Understood

Full Member

• Dec 12, 2014

• #6

pete1987RRC said:

Any diesel specialist will have some

Click to expand...

Even Halfrauds sell it !!!

 

rodntod

Active Member

• Dec 12, 2014

• #7

Cheers all,it's the halfrauds stuff i'm using,funny thing is it's only one that's leaking.I'll replace it in the morning,again

 

Datatek

Well-Known Member

• Dec 13, 2014

• #8

rodntod said:

Cheers all,it's the halfrauds stuff i'm using,funny thing is it's only one that's leaking.I'll replace it in the morning,again

Click to expand...

Make sure the spigot is not cracked where you have been pulling it about to get pipe on and off.