jamesmartin
Well-Known Member
series are the same flange 607185,later dust shields as fitted with stc4475 might not fit properly but you can swap your old one if thats the case
On a related note I'm having a hell of a time trying to get the nut undone, its a nyloc type and stuck fast......any ideas?
Tried air gun, big bar, hammer and chisel! Don't tell me its left hand thread.....
jamesmartin
Well-Known Member
no std rh thread,long bar or big gun
The thing is I just wanted to change the seal for completeness..... I don't think it leaks at the moment but if I put heat on it then it will ruin it.
Think I'll hope for the best at the moment as its all stripped down to a rolling chassis so no weight on it.
Once its back together I can put a ton of sand in the tub and hopefully that'll hold the wheels to the floor so I can get better traction on the nut....of course then I'll have to do it laying on my back underneath it
Think I'll hope for the best at the moment as its all stripped down to a rolling chassis so no weight on it.
Once its back together I can put a ton of sand in the tub and hopefully that'll hold the wheels to the floor so I can get better traction on the nut....of course then I'll have to do it laying on my back underneath it
jamesmartin
Well-Known Member
whack the sides each flat of the nut with a large punch and hammer it will stretch the nut easing itThe thing is I just wanted to change the seal for completeness..... I don't think it leaks at the moment but if I put heat on it then it will ruin it.
Think I'll hope for the best at the moment as its all stripped down to a rolling chassis so no weight on it.
Once its back together I can put a ton of sand in the tub and hopefully that'll hold the wheels to the floor so I can get better traction on the nut....of course then I'll have to do it laying on my back underneath it
