robert.

New Member
Hello everyone,

Was wondering if anyone has done a recent gearbox rebuild on a 2A. I don't know what way the 3rd/4th gear synchro mesh should be turned round?
It is very similar on both ends :confused:

Help on this would be greatly appreciated.
 
The splines are different on each end to clear the gear, have a look you will figure it out.

3rd4thsynchro1.jpg
 
Thank's for the replies!
I shall try and get things right tomorrow using the explanation you have given. The image should also be a good guide.
Its just a bit frustrating not knowing what way it goes as it fits both ways. It would be a nightmare putting the whole gearbox together just to realise the synchro was facing the wrong way :eek:
 
it only fits properly one way ,look at splines iun the synchro hub both ends then think of the snap ring
 

Similar threads