cornishboater

Well-Known Member
Just refurbishing my seats and cleaning/greasing the drive mechanisms. At either end of the drive screws there appears to be what looks like rubber bump washers. These have just gone hard and have disintegrated, couple of questions, do I really need them and are they just there to prevent the metal to metal contact at the end of travel. I was thinking of getting some polyurethane rod and making replacements, I can put a split line in them to be able to push over the screws. However, if they ain’t fully necessary I would probably not bother. I have looked on LRCat but there are no details of the seats for some reason, has anyone got a detail drawing of the mechanism?
 
Just refurbishing my seats and cleaning/greasing the drive mechanisms. At either end of the drive screws there appears to be what looks like rubber bump washers. These have just gone hard and have disintegrated, couple of questions, do I really need them and are they just there to prevent the metal to metal contact at the end of travel. I was thinking of getting some polyurethane rod and making replacements, I can put a split line in them to be able to push over the screws. However, if they ain’t fully necessary I would probably not bother. I have looked on LRCat but there are no details of the seats for some reason, has anyone got a detail drawing of the mechanism?
The mechanism could jam without the bump stops. I use electrical grommets as the bump stops, they come in many diameters and thicknesses. Cut to fit then a loop of wire in the groove with the ends twisted together ensures they stay put.
 
Found the little buggers, a very cheap and easy solution Keith, I also had some very small zip ties which fitted in the groove a treat. The grommets I had had a tad bigger inner diameter so I just hacked a bit off and with the zip ties they're are as firm as anything. Now on to the the next project, only 499 left now........
 

Similar threads