H

Hybrid309

Member

• Oct 19, 2014

• #1

Got a core plug that's rusty and leaking, how hard are these to replace and if so best way of fitting the new plugs, I'm going to replace all 6 as they all look abit corroded,
Thanks

 

jamesmartin

Well-Known Member

• Oct 19, 2014

• #2

hit one side till then spin on edge then prise out ,mole grips are good for that , clean hole ,locktite edge and tap in using a loose fitting socket ,ensuring they are square and lip is just in from the hole edge

 

freelance

Well-Known Member

• Oct 19, 2014

• #3

as above, make sure you have enough room to refit them squarely, easy if block is on the bench , can be difficult in situ, behind ancillaries etc.

 

H

Hybrid309

Member

• Oct 19, 2014

• #4

Thanks a lot lads