Status
Not open for further replies.

bustersbus

Well-Known Member
RENEWING AN INJECTOR PIPE.

Had a wee bit of seepage from the injector pipe union so decided to change the pipe.

Here’s how ah did it…

The pipes…

Injectorpiperenewal001.jpg


Ah removed the hose from the cyclone breather to make it a bit easier to get to and tucked it out of the way…

Injectorpiperenewal002.jpg


Then ah removed the two clamps that hold the pipes together…

Injectorpiperenewal003.jpg


Injectorpiperenewal004.jpg


As it was number one pipe, ah found it easier to remove it from under the bus…

Injectorpiperenewal005.jpg


Injectorpiperenewal006.jpg


Then back up top to undo and remove the pipe…

Injectorpiperenewal007.jpg


Injectorpiperenewal008.jpg


The old and new pipe…

Injectorpiperenewal009.jpg


Refitting is pretty much the reverse. Ah stuck the top union on by a couple of turns just to hold it before fitting the bottom.

Here’s some photies of it going back in…

Injectorpiperenewal010.jpg


Injectorpiperenewal012.jpg


Injectorpiperenewal013.jpg


Injectorpiperenewal014.jpg


Injectorpiperenewal015.jpg


That’s it, job done ;) :D
 
Status
Not open for further replies.

Similar threads