Status
Not open for further replies.

bustersbus

Well-Known Member
Removing door hinges from the bulkhead.

Here’s how Ah did it…..

To remove the hinge from the bulkhead Ah used an impact driver to get the bolts out…

hingeremoval001.jpg


hingeremoval002.jpg


To see this…

hingeremoval004.jpg


Usin’ a thinnish screwdriver ah stuck it in the captive nuts and lifted them out…

hingeremoval006.jpg


hingeremoval007.jpg


Ah threw the old ones away and replaced with some shiny new ones…

hingeremoval005.jpg


Then it’s just a case of stickin’ the new ones in usin’ the screwdriver again to get them on…

hingeremoval008.jpg


Once the captive nuts were fitted, it was just a case of stickin’ some copper grease on the bolts and stickin’ the hinge back on with the gasket.

A wee tip… do the top hinge first because if the captive nuts fall in it’s easier to get them out from the bottom hole usin’ a long screwdriver and magnet.

That’s it, job done ;):D
 
Status
Not open for further replies.

Similar threads