daddy2coull
Active Member
Had some play in the rear wheel bearings on my disc brakes rear axle. Pulled the OSR apart and changed the bearings and adjusted them up no problems at all. However, pulled the NSR apart and the nuts were loose. Replaced the bearings using timken bearings but they will not adjust correctly. If I even spin the inner nut up even by hand the hub locks up completely. I’ve tried leaving the inner fairly slack and tightening up the outer nut but I can’t get rid of the excessive play. I’m now about to order another wheel bearing kit. But does anyone have any suggestions as to what’s causing this? I eondered if it’s worth ordering a replacement stub, there’s no obvious wear on it