Folks have fitted a new seal and flange kit to disco 1 but when I tighten the flange retainer bolt (not the nut type) to the 72nm if pretty much locks up and wont spin by hand but will at a push if i put socket on the nut to turn it.
Fitting the halfshafts to see if the flange spins when they are in is also a non starter.
If I back the nut off on teh flange it all becomes looser and will spin.
Do I need to adjust spacers? Ideas please.
Thanks
Fitting the halfshafts to see if the flange spins when they are in is also a non starter.
If I back the nut off on teh flange it all becomes looser and will spin.
Do I need to adjust spacers? Ideas please.
Thanks