Rangerovergav

Rangerovergav

New Member
Hi I'm Gav a Range Rover L322 owner

I was driving along fine all gear changes fine stopped at junction on roundabout went to pull off car revved with no drive. I switched off and on a few times managed to move enough to get over roundabout. Rolled it in to a car park and got recovered got home plugged in the Snap On Solus Ultra no codes on engine or gearbox but 3 in transfer box. These are as follows

0x5212 battery under voltage

0x52ED instr 2 lost from can

0x52F2 instr 3 lost from can

If I leave it a bit it will go in drive then after yards lose drive and all other gears

Anyone help please as I don't want to chase my tail and spend money I don't need to.
 
range rovers are all about spending money! Where's the screaming hair pulling emoji face thing!!
there are some real wizards on here buddy, there'll be one along in a bus soon! Good luck! Do you have and history on the box, I.e. Oil and filter changes? There is a long list of things to verify on the l322 before any decisions should be made about spending any money!
 
It had a recon box and Torque converter 20,000 miles and 3 years ago. Services not sure but oil level is fine I'm thinking transfer motor is putting it in neutral?
 
AFAIK transfer box electrics are just the hi lo actuator.

Maybe not fully engaging.

PowerfulUK have a vid on youtube about removing it and bench testing it.
 
That being said it looks like transfer box;)

Had same issue myself after disturbing a 'sleeping' hi lo......

Sh@t my pants, did a google, whipped off the actuator, stripped it, 10 seconds of stunned WTF moment as the planet gears fell across the floor, cleaned commutator, checked brushes, did a bench power up, re timed it for re entry, all worked ticketyboo.

Don't neglect switch, remove console and clean Coca Cola/Red Bull from the gubbins with contact cleaner.
 
Last edited:
See your twin post. Bemble has replied to it. When he speaks, LISTEN!
 
Rangerovergav said:
Hi I'm Gav a Range Rover L322 owner

I was driving along fine all gear changes fine stopped at junction on roundabout went to pull off car revved with no drive. I switched off and on a few times managed to move enough to get over roundabout. Rolled it in to a car park and got recovered got home plugged in the Snap On Solus Ultra no codes on engine or gearbox but 3 in transfer box. These are as follows

0x5212 battery under voltage

0x52ED instr 2 lost from can

0x52F2 instr 3 lost from can

If I leave it a bit it will go in drive then after yards lose drive and all other gears

Anyone help please as I don't want to chase my tail and spend money I don't need to.
Click to expand...
Did you get this resolved? I have the same problem
 
He keen to watch this thread as I have just had mine recovered back home with same fault but found i had the 37 still fitted in the fusebox so don't understand how mine has drove at all since I bought it
 
Mick10 said:
He keen to watch this thread as I have just had mine recovered back home with same fault but found i had the 37 still fitted in the fusebox so don't understand how mine has drove at all since I bought it
Click to expand...

Start a new thread and hope Bemble see it!
 
You must log in or register to reply here.

Similar threads

C
L322 td6 auto 2005 No Drive when hot
Replies
12
Views
930
chu017
C
D
No drive but grinding noise
Replies
8
Views
1K
rebeccaSP91
rebeccaSP91
dantaylor360
Speedo Drive gear
Replies
12
Views
526
Rangieman123
Rangieman123
S
2001 range rover p38 auto gear dox issues
Replies
2
Views
864
kermit_rr
kermit_rr
Roverdrive
L322 L322 Battery strangeness
Replies
16
Views
865
kermit_rr
kermit_rr