pricey

Active Member
silly question i suppose but as i have just put new shoes on the series3 i wondered what pressures to put in i am running 235/85/16 and would like to know what sort of pressure to put in for mainly road use cheers
 
cheers its a lot higher than i first thought but hey cant disagree coz i aint got no idea
 
well as your running them on the road 35 should be fine. i run mine at 30-32 but mine gets used 50/50 road laning, so that works well for me, but i think most others run 35 for the road. what boots did you get?

G
 
if you aint got power steering, you might be better off with 40 in the front.
 
its just i put 30 in my last tyres and they wore out in the centres alone but they were only 235 70 16
 
FFs
wot do you all think Big Tyre = big pressures????

30 tops more like 24

for a Series 2 (Close enough to a series 3)

Series Two Club
 

Attachments

  • Recommended Tyre Pressures.zip
    5.5 KB · Views: 186
so what does it say next to it?

It says "if living in Ireland please inflate to max pressure as this will lessen the damage caused by the massive pot holes to your wheel rims":eek:

Besides that i do a lot of towing and also the vehicle is always loaded!
 
It says " max pressure ":eek:

!



[FONT='Times New Roman', Times, Serif, serif]Maximum Inflation Pressure: most know that the sidewall of their tires contains information on maximum inflation pressure. Many do not know that this does not necessarily tell you the correct inflation pressure for the tire on your particular vehicle. Vehicle manufacturers place this information on a placard which is usually located inside the driver’s side door jamb. For various reasons, some manufacturers recommend a tire pressure below the maximum pressure [/FONT]
 
my thoughts exactly looks like i will keep them at 25 psi feels ok on road so i guess my first instinct may be right cheers all
 
I tend to run mine at 25, a couple of pounds above the minimum allowed for RTVs (allows for gauge variations,) but raise then to about 35 if I've got a long journey (not very often)
 
It says in the Haynes book:

6.00 x 16, 6.50 x 16, 7.00 x 16, 7.10 x 16 and 7.50 x 16

SWB & LWB models

tyre pressure front and rear 25 lb/square inch (1.8 kg/square cm)
Note: if the load is over 500 lb (250kg) the rear tyre pressures should be increased to 30 lb/square inch (2.1 kg/square cm)

Well thats what it says in the haynes manual....me personally, I'm gonna wack 80lb in front tyres and pretend I got PAS:eek:
 
dint ferget that once yer gort yer 80psi in yer tyres, the treads wint work properly so wint get rid of the water and yule end up with that racing slick effect.
 

Similar threads