steamcoaster
Active Member
Slob knows where this is going from other threads - but I have a spare gearbox in the garage from a Series 3. I'll go and have a look and see if it has those bits on.
steamcoaster
Active Member
I found the clutch lever and push rod from salve cylinder. So which is the plastic thingy?
steamcoaster
Active Member
White plastic clip thing. Holds slave cylinder push rod to clutch release lever. I must say, we do put an awful lot of trust in the little bit of plastic don't we? Clip appears complete.
What do you want to do?
I'm looking for some screws to hold floor down as they seem to be a short supply too. Deepish puddles at speed a bit scary for passengers.
What do you want to do?
I'm looking for some screws to hold floor down as they seem to be a short supply too. Deepish puddles at speed a bit scary for passengers.
GRUNT
Well-Known Member
Hey up Slob did you get the clip sorted? If not there 79p from main dealers less from Beamends. The one I got from Beamends broke as I was trying to fit it, I'm going to try main dealers one tonight but dont think I'll have any better luck. So I'll make one out of a broken one and an old spring. I've tried tie wraps but they didn't hold it well enough for my liking.
I'm trying to fit the clip through the slave cylinder hole does anyone have any tips for doing this? A bit of practice finding the missuses G spot might help.
I'm trying to fit the clip through the slave cylinder hole does anyone have any tips for doing this? A bit of practice finding the missuses G spot might help.
