nobber
Well-Known Member
my lt77 has a worn mainshaft , Ive replaced the output gear and that took some of the shunt away but not all , Ive put grease on the shaft splines before i put the gear on and that also deadened the shunt a little.
now, what i propose is this , my gear is not cross drilled , nor can i use a cross drilled gear as my box is to old , so , what if i used something else to 'fill the gaps' as it were in between the splines?
such as high temp gasket sealant or similar?
i know it wont cure a worn shaft but it may take the annoying shunt away eh?
now, what i propose is this , my gear is not cross drilled , nor can i use a cross drilled gear as my box is to old , so , what if i used something else to 'fill the gaps' as it were in between the splines?
such as high temp gasket sealant or similar?
i know it wont cure a worn shaft but it may take the annoying shunt away eh?