2_stroke

New Member
Morning all :)

just wondering if anyone has any tips on lineing up all the body work on my series 3 88 hard top, its all been stripped and put on a discovery chassis.

to be honest im nearly there and the pannel gaps and shut lines look prety good id just like to be sure its right :eek:

thanks all

Edward
 
this is it as it stands :) i did a bit more to it yesterday evening so its a bit better than this now

Photo0364.jpg
 
it was over lapping but ive supported the front of the rear tub now and its made all a bit better, then i took the roof back off and got on with ajusting the angle of the window with the ruler and its good even gap there now, i could see plain as day the angle of the screen was too far back when i paied some attention.

edward
 
Please realise that you haven't got a series three with a disco chassis, you've got a disco with S3 bodywork and the reg no and paperwork should reflect this. You're might have to tell the DVLA too.
 
i know ive been through all this on my build thread thats been lost in the sands of time.

its going to come back to me on a q plate as ive not used enough of the disco to call it a disco nor enough series to call it a series and its got to go through an sva test
 
i know ive been through all this on my build thread thats been lost in the sands of time.

its going to come back to me on a q plate as ive not used enough of the disco to call it a disco nor enough series to call it a series and its got to go through an sva test

Excellent - good to see someone who understands the rules! - It's looking good so far.
 

Similar threads