JPSolutions
New Member
I am having problems with my P38 4.6 HSE, sticking in low range.
Reading the workshop manual is states that the position switches on the ratio contol motor are fed a 5V feed from the ecu, but it does not state wether the actual motor drive supply is 5V or 12V.
Any assitance with this would be greatly appreciated, I was going to stick 12v on them motor contacts to see if it runs, but if its only a 5V motor that might not be such a good thing !!
Thanks in advance
Rob
Reading the workshop manual is states that the position switches on the ratio contol motor are fed a 5V feed from the ecu, but it does not state wether the actual motor drive supply is 5V or 12V.
Any assitance with this would be greatly appreciated, I was going to stick 12v on them motor contacts to see if it runs, but if its only a 5V motor that might not be such a good thing !!
Thanks in advance
Rob