Hi, another problem with my rangie.
Recently had a new clutch kit fitted all was well, but yesterday clutch pedal went to floor and was leaking fluid from slave, fitted new slave cylinder but just have no pressure in pedal after bleeding it, pedal just stays on the floor.
I had read posts about sheard pins and about clutch arm been able to be moved too far, my arm is pressurized when pushing by hand towards front off the car and no movement to rear of car, seems pins are ok?
If I pump the pedal by hand when its slack it forces piston out the end of slave, Could it do that if not bleed proberly?
thnaks
Recently had a new clutch kit fitted all was well, but yesterday clutch pedal went to floor and was leaking fluid from slave, fitted new slave cylinder but just have no pressure in pedal after bleeding it, pedal just stays on the floor.
I had read posts about sheard pins and about clutch arm been able to be moved too far, my arm is pressurized when pushing by hand towards front off the car and no movement to rear of car, seems pins are ok?
If I pump the pedal by hand when its slack it forces piston out the end of slave, Could it do that if not bleed proberly?
thnaks