teagle
New Member
Hi all, I have been following advice on here for a while now but this is my first post, having been heavily defeated by this problem...
The landy overheats inside a couple of minutes. I replaced the head gasket 2 months ago and it ran fine for a few weeks, having torqued and re-torqued. Then it started overheating.. the oil also went grey... I had a compression test done and it was all fine, i have looked in the expansion tank for bubbling, and its not. I ran it without the thermostat in for a bit, still overheated. I have just replaced the rad, water pump, thermo stat and fan belt, all to no avail.. rapid overheating of the engine.
If the compression is good, can there still be a crack in the head or block? What do i do next?!
Thanks for any help in advance..
The landy overheats inside a couple of minutes. I replaced the head gasket 2 months ago and it ran fine for a few weeks, having torqued and re-torqued. Then it started overheating.. the oil also went grey... I had a compression test done and it was all fine, i have looked in the expansion tank for bubbling, and its not. I ran it without the thermostat in for a bit, still overheated. I have just replaced the rad, water pump, thermo stat and fan belt, all to no avail.. rapid overheating of the engine.
If the compression is good, can there still be a crack in the head or block? What do i do next?!
Thanks for any help in advance..