gavin hill

Member

• Mar 2, 2019

• #1

Morning all.

I have the open book on my hevac screen. It all seems to be working fine Hot and cold air blowing from every Direction Aircon working as it should but the Blower don’t turn completely off only turns to lowest setting. Thanks I have a 4.6 engine 2000

 

Datatek

Well-Known Member

• Mar 2, 2019

• #2

gavin hill said:

Morning all.

I have the open book on my hevac screen. It all seems to be working fine Hot and cold air blowing from every Direction Aircon working as it should but the Blower don’t turn completely off only turns to lowest setting. Thanks I have a 4.6 engine 2000

Click to expand...

The fans do not turn off completely on either of mine so I assume that it's normal. The book symbol is usually due to a sticking blend motor. diagnostics would tell you where the problem lies.

 

gavin hill

Member

• Mar 2, 2019

• #3

Thanks mate I know before I had the car the heater matrix was done if that has anything to do with it I don’t no

 

Datatek

Well-Known Member

• Mar 2, 2019

• #4

gavin hill said:

Thanks mate I know before I had the car the heater matrix was done if that has anything to do with it I don’t no

Click to expand...

Could be bits of the sponge seals are blocking full movement of the blend flap.

 

Dopey

Well-Known Member

• Mar 2, 2019

• #5

 

RangeRoller dt

Well-Sprung Member

• Mar 2, 2019

• #6

After my P38 was abandoned for few years the hevac LCD would show the fan either on 4 or usually 1bar and refuse to move. After a while it loosened up and goes to just fan symbol now. If on hot you can still feel warm air penetrating through but presume this means off. The dial can be taken out and cleaned with contact cleaner