M

mrmotorvator

New Member
i have a tdv8 3.6 2010 and it will not start tested starter and works fine no power to fuel pump also tested and works fine
 
Is there an aftermarket immobiliser fitted? do the dash warning lights come on? do the brake lights work?
 
no aftermarket alarm you put fob on centre console press start button nothing happens dash is lit .it says press brake to start when you do the ignition turns off . brake lights work ok switch renewed if i give 12v to the energizer wire on the starter engine turns over but does not start . no 12v feed to fuel pump
 
Then it sounds like a problem with the brake pedal switch or wiring, there are two sets of contacts, one normally open, one normally closed. If the two do not change state correctly then you'll get the symptoms you describe in your second post.
Are you a trader?
 
im a retired mechanic mot tester not in the trade anymore .i renewed the brake light switch still same if i feed the tank pump with a live feed and also give a feed to starter it will run .otherwise just turns off
 
You must log in or register to reply here.

Similar threads

kricktd5
L332 abs/ HDC
Replies
1
Views
560
Datatek
Datatek
M
Classic Range Rover Suffix D Starting Issues - Advice required please
Replies
6
Views
405
Datatek
Datatek
B
MOT failure
Replies
4
Views
616
R-Two-D2
R
J
L322 suspension fault light
Replies
8
Views
676
kermit_rr
kermit_rr
F
P38A Starting issues.
Replies
7
Views
337
kermit_rr
kermit_rr