josh00mac

Active Member
Before I start taking things apart, do the P38 rear light units disassemble so that I can clean out this mould or are they fairly sealed/inaccessible?

Any advice welcome
FullSizeRender.jpg

Josh
 
New set of rear tailgate light units the only solution?

Upsetting!

I had similar issue - i removed and put hot water + bleach through the bulb holder, washed out thoroughly, allowed to dry with little bit of heat.
 
Take them off, bulbs out, bleach and water in with a bit of light chain, give it a good shake wash out and recover chain. Dry as best you can with kitchen roll then leave in the airing cupboard for a day or two. Worth a try.;)
 
I use crushed ice cubes to clean my lights out anything abrasive will do it as said tho start with some bleach to kill the mould then some crushed ic give it a shake then blow out with an air line
 
For anyone interested I took these off and the bottom is very poorly sealed by design. I soaked the bottom of the lights in hot water for an hour and aggravated the road muck with small flexi-brush. Shifted nicely - very simple job
 

Similar threads