oakey

oakey

Well-Known Member
Full Member
V8 4.6 auto 1995 178k
Purely based on the dashboard figures, I used to get approx 20 - 21 mpg
For the past few weeks I get approx 25 - 16 mpg.
Anyone any ideas?
I just changed all plugs and leads and they certainly needed it.
All the plugs looked the right colour so I guess the mixture is ok
I have a nanocom, what should I look for?
 
I'm guessing anything over 13mpg is an achievement for our antique V8's.

You're creeping into diesel RR territory with that MPG ;)

Minus the reliability, of course ;)
 
On a run I often get an indicated 22 on the dash, and have even seen it say 25 Ha! Ha!
Not sure its got it right though. I am going to do a brim-to-brim if I can.
 
My dash may be miles out from actual but is the same dash before so should be comparable.
Dont know what a diesel would do bt it sure wouldnt have the V8 burble :)
 
The Dash readout has been known on some to be quite accurate..

I've read quite a few owners who have gotten north of 20mpg with the V8

Depends heavily on your right foot i suppose ;)

The diesels can do from 22-32mpg depends again on the cars health and right foot ;)
 
oakey said:
Why has mine suddenly dropped to 15 ish tho?
Puzzling
Click to expand...

More town driving?

If you check on the Nanocom are the O2 sensor readings changing? If not an O2 sensor might be acting up. Or maybe it just needs to get used to the new setup and trim itself?
 
My diesel has a long term average, checked brim to brim on every fill, of 24 mpg. On a long run it can get close to 30. A recent run on twisty hilly A roads 5 up turned in 27.2mpg.
 
From a brim to brim i get 22.1 mpg average out of my V8 which is quite surprising tbh.

My old diesel classic used to get 25-28 so i'm quite happy with my V8 ;)
 
Thank you all
If O2 sensors were out, then would plugs not show too rich? I will check them hopefully tomorrow ta. And they should be changing all the time?
How do I rest adaptive values? What should I set them to?
 
Don't reset adaptive values it's pointless and will result in a loss of mpg for a spell! Gems will adapt all by itself. Resetting adaptive values on nanocom is a blunt instrument and resets everything. Having said that is your car on lpg?
I wouldn't worry about it tbh it's an average and reflects long term eg a 150m drive on the motorway may show 23mpg. It would take many short journeys at 13mpg to significantly affect the average. 15-16 mpg is a good representation of shortish journeys and I doubt anything's wrong at that.
 
No I don't have lpg
I am only getting 16 on a long run albeit not on motorway for long.
But same journey used to be 20 ish.
When it first dropped a few weeks ago it was an average of over 3k at about 20 then slowly plummeted
 
In fact I'd suggest your fuel trims are very well suited. The only time I'd reset fuel trims is after major engine work. Lpg does mess up gems fuel trims though. Gems is quite a slow adaptor not a fault just made that way which plays havoc with lpg/petrol trims. Thor is much quicker.
It may have taken years to arrive at your fuel trims it may take years before you see 16 mpg again!
 
No I have a habit of monitoring mpg.
When it initially dropped I was doing shorter journeys and then reset it when I was doing a long journey to see what happened and it stayed low
 
oakey said:
No I have a habit of monitoring mpg.
When it initially dropped I was doing shorter journeys and then reset it when I was doing a long journey to see what happened and it stayed low
Click to expand...
Very odd. Whenever I have reset it from appalling MPG (known problems with car and only round-town driving) and restarted/reset the calculations and driven gently on purpose it has always been very positive that I am doing a higher MPG.
 
It's difficult to recommend anything but check the coolant temp sensor. Check the maf at 1000 and 3000 rpm. Check the actual brim to brim mpg. Check the plugs are the same. Air conditioning on? Alternator/ battery dodgy? Check plug leads for Sparks in the pitch dark. Coil breaking down after plug change?
 
You must log in or register to reply here.

Similar threads

300bhp/ton
P38A 4.6 fault codes
Replies
14
Views
1K
Grrrrrr
Grrrrrr
MrJ191
P38 2.5 Diesel BeCM
Replies
4
Views
1K
Grrrrrr
Grrrrrr
D
TD5 injector disbalance / engine runs rough / white smoke
Replies
2
Views
1K
brianp38dse
brianp38dse
xDParis64
Freelander 1 Converting from wasted spark to distributor (or Visa Versa)
Replies
0
Views
318
xDParis64
xDParis64
D
TD5 white smoke / injector disbalance / running rough
Replies
5
Views
2K
Dirnie
D