Morning Landyzone, I'm looking to see if anyone has found a means of making secondary door seals like those that were available from overfinch back in the day? From what I can gather they were essentially a an extruded profile rubber strip:
that was bonded to the window frame by means of pre-applied double sided tape:
Rather than go blindly prowling rubber catalogues, not that that sounds at all dodgy, I figure there's nothing new under the sun, so given it's ~30+ years since the RRC was Overfinch's bread and butter I guess that some of us enthusiasts will have made something for their D1/D2/RRC, maybe a stock profile, or a part from another vehicle?
Since two heads are better than one, I'm going to cross post this into the Discovery section, and if I get any good answers in either thread, I'll update the oposite one - cheers
that was bonded to the window frame by means of pre-applied double sided tape:
Rather than go blindly prowling rubber catalogues, not that that sounds at all dodgy, I figure there's nothing new under the sun, so given it's ~30+ years since the RRC was Overfinch's bread and butter I guess that some of us enthusiasts will have made something for their D1/D2/RRC, maybe a stock profile, or a part from another vehicle?
Since two heads are better than one, I'm going to cross post this into the Discovery section, and if I get any good answers in either thread, I'll update the oposite one - cheers
