D

dezhd

New Member

• Nov 6, 2012

• #1

Hi all back again with a new problem.
Have recently changed the Injector harness, EGR removal kit,new waste gate actuator valve,but when the engine is pushed hard it goes into limp mode and wont rev above 1500rpm.The only way i can get full power back is to disconnect the battery.Any ideas or fixes for this problem.If driven normally everything seems fine, pulls fine and has plenty of power its just when pushed hard thanks dez.

 

jamesmartin

Well-Known Member

• Nov 6, 2012

• #2

sounds like waste gate isnt opening

 

sierrafery

Well-Known Member

• Nov 6, 2012

• #3

i suppose that it's an auto then.... the best is to plug in a tester and scan the EAT ECU first

 

D

dezhd

New Member

• Nov 6, 2012

• #4

thanks for the replies its a manual and have been able to move the waste gate arm with pliers ?

 

D

dezhd

New Member

• Nov 17, 2012

• #5

Hi is there any way i can do any tests as dont have have a tester available thanks Dez.