I have a Freelander 1 1.8 petrol. When bought all appeared fine with the three amigos, however heavy braking on a damp surface revealed that all was not as it seemed! Further investigation revealed that the lights had been blanked with bits of foam jammed into them to allow it pass an MOT.
Several sessions later, both front sensors replaced and both front hubs as the reluctor rings were gone, and tow of the three amigos were now working correctly (Yaaaay!)
The HDC light however is still on constantly.
I have a generic code reader that will read and reset the engine fault codes, but does not seem to do the brake ones, is there a way of resetting these codes without using an OBDII reader? - most cars I have worked on have a system of switching ignition on and off again, foot on and off brake pedal or some similar sequence, but I can't find one for the Freelander.
Otherwise, what are the likely culprits for just the HDC light to stay on?
Several sessions later, both front sensors replaced and both front hubs as the reluctor rings were gone, and tow of the three amigos were now working correctly (Yaaaay!)
The HDC light however is still on constantly.
I have a generic code reader that will read and reset the engine fault codes, but does not seem to do the brake ones, is there a way of resetting these codes without using an OBDII reader? - most cars I have worked on have a system of switching ignition on and off again, foot on and off brake pedal or some similar sequence, but I can't find one for the Freelander.
Otherwise, what are the likely culprits for just the HDC light to stay on?