B

brianconwy

Well-Known Member

• Dec 24, 2019

• #1

I have fitted a replacement TD5 to our disco. The installation is nearly finished. It is just thew wiring. I have connected up the passenger side and a couple of the glow plug connectors. The silly question is where does the main loom sit? Do I bolt on ther fuel cooler and fasten the loom below it or should I connect the electrical bit first and then the fuel cooler over it?

Thanks

 

Brown

Well-Known Member

Full Member

• Dec 24, 2019

• #2

I think you're better off being able to take the fuel cooler off without having to disconnect all the wiring. That's how I've fitted mine.

 

B

brianconwy

Well-Known Member

• Dec 24, 2019

• #3

I am putting it all back on. The fuel cooler is connected but not bolted into podition. I am now connecting up the loom. I need to know if it just sits beneath the fuel cooler. If that is the case then I will bolt the cooler in position and the connect up the wiring. Thanks.

 

Brown

Well-Known Member

Full Member

• Dec 25, 2019

• #4

Yes, mine sits beneath and slightly inboard of the fuel cooler.

 

sierrafery

Well-Known Member

• Dec 25, 2019

• #5

Yes, it runs beneath the cooler IIRC

 

B

brianconwy

Well-Known Member

• Dec 25, 2019

• #6

Thanks. Thats good to know. i will bolt up the fuel cooler and then fit remaining connections. Not allowed near it today though. lol.