R

redhotmax

Member

• Nov 25, 2013

• #1

TD5 year 2000

My Disco is not running too well at the moment so amongst other jobs i decided to renew the injector o rings and copper washers. Not a difficult job i thought. Now wish i hadn't disturbed them. First time i used Britpart parts but the motor then sounded so much louder so on a second attempt i used land rover branded parts but the motor still sounds loud a bit like a knackered old transit van. I have been meticulous ensuring all the seal surfaces are clean. The copper washers i was supplied with were flat copper washers, they look like they would need quite a force to deform to make a seal. i have seen on the forum reference to ribbed washers. Any ideas, or could it be a knackered injector.

Best regards
Red

 

50 pence

New Member

• Nov 25, 2013

• #2

Did you reset the injector clearances ?.

 

johnlad

Well-Known Member

• Nov 25, 2013

• #3

50 pence said:

did you reset the injector clearances ?.

Click to expand...

+1

 

R

redhotmax

Member

• Nov 26, 2013

• #4

Hi,

Yes, tightened down by hand then backed off one full turn. Clearance does seem a lot though. Should I try 1/2 a turn?
I fitted new o rings and new flat copper washers (LR). Is this the same as a Discovery 2 CDL kit?

Oil level not rising but vehicle is sluggish in low revs

 

johnlad

Well-Known Member

• Nov 26, 2013

• #5

Did you make sure the cam lobes were at there highest on each cylinder before tightening injectors

 

R

redhotmax

Member

• Nov 26, 2013

• #6

Yes, i believe so. There is quite a large angle of cam lobe highest surface that the rocker
contacts as it rotates. This was at the point I make the adjustment

 

R

redhotmax

Member

• Nov 26, 2013

• #7

Can I remove the rocker box lid briefly whilst engine is running to see if i can find which ones are rattling or is oil going to shoot everywhere?

 

ratty

I'm not special I'm limited edition

• Nov 26, 2013

• #8

redhotmax said:

Can I remove the rocker box lid briefly whilst engine is running to see if i can find which ones are rattling or is oil going to shoot everywhere?

Click to expand...

it'll get very messy, very quickly if ya take the cover off.

 

50 pence

New Member

• Nov 26, 2013

• #9

Have a look at www.discovery2.co.uk

He has done a guide with puctures. You can check what you have done against it.

Details of my lever kits are at the top of hus cdl install write up.