nigxls

Member
Hi all, I am looking for the part no for the wire from the switch to the starter solenoid, the red and white one.
Mine has had a shonky repair just past the mid way connector by using a connector block.
It works at the moment but I'd like to replace the cable before it fails again but am struggling to find the part no anywhere.
Thanks
 
Its just a cable, part of the loom and not a separate item.
If it has been repaired with a scotch block connector then needs to be fixed, they are rubbish in the long term and cause no end of trouble.:mad:
A proper crimp connector or solder together and cover with heat shrink Even a chock block is fine.
 
Ah thought that maybe the case.
I’ll just run a new cable and re route away from the back of the engine.
Thanks
 
the part number will be for a complete loom (very expensive) as above either run a new separate wire you can order the correct colour coded wire from lots of places (I used this chap on ebay for my rebuild LINK) or just replace the repair with a proper solder and adhesive heat shrink repair.
 

Similar threads