I have lost some teeth on my fly wheel, and its in a place with no teeth atm so no start, which bit is it i need to turn to get it to start?

I know when the AA man did it, he got under with bar and turned it, what bar would he have used can i just go buy one?


Now I am sure I need a new fly wheel teeth, want to get it started again, before i book it into some where to make sure I can get it to them.

IMG_4004 | Flickr - Photo Sharing!

I am guessing he turned the big wheel on the left to get the fly wheel to move round?

just get a push/pull start

If you can't push it, you could put a socket onto the crank pulley bolt and turn the engine round a few degrees with that.

A strong arm from any 1/2" socket set should suffice.

Don't forget to have it out of gear if you are turning by hand.

OSD

Stick it in top gear, hand brake off and move it about a yard. Handbrake on, out of gear, turn key and away you go.