flash42

Active Member

• Dec 28, 2008

• #1

up until now i can deal with no heating but its now rediculous trying to drive and still feel my fingers.

i know its the matrix thats dead, and need to replace it, got all the tools i reckon ill need, can anyone tell me how to do it?

cheers

flash

 

Griffdowg

New Member

• Dec 28, 2008

• #2

aint it in the haynes manual? i assume you drill out all the rivets to the heater box and its in there somewhere

sorry for being no help.

G

 

flash42

Active Member

• Dec 28, 2008

• #3

hmm, ill go have a look, considering i got the manual for xmas i completely forgot to look lol

 

bustersbus

Well-Known Member

• Dec 28, 2008

• #4

Ah think ye need to take the heater box out, drill out the rivets (3 rivets are under the rubber seal), take off the cover,air duct and seal and lift out the matrix. Then ye need to fit the foam rubber to the casing and stick the new matrix in then check that the valve flaps are workin' without stickin' and rivet the top cover back on.

 

Danmids

New Member

• Dec 29, 2008

• #5

You do need to take the heater unit out of the vehicle. No drilling of rivets required on mine, all self tappers. Remove old matrix and fit new with foam. The heater unit top mounting screws are very awkward to get to. I think Mr Haynes recommends taking the bonnet off, but you can just about manage it without. Remember to line the plastic under-wing intake up before resecuring the unit to the bulkhead!
Hope this helps

 

baggyjim

New Member

• Dec 29, 2008

• #6

hi take a look at page 126 of jan 09 issue of landrover owner mag

 

Shifty1962

Well-Known Member

• Dec 29, 2008

• #7

Bonnet takes 10 seconds to get off and gives loads more room and light to work with.
Drill rivets and replace with self tappers if you dont have a rivet gun.
Make sure you get the right matrix as they come with different pipe connections. Horizontal or vertical.