F

fatboyz

New Member

• Jan 28, 2009

• #1

hi a mate of mine has just filled, well half filled one hub on his landy but he cant get anymore in there it seems to be full , he drained all the old oil out undone the 4 bolts on the top took the cap off and filled all he could but its only used about half a sachet any ideas . . . . . . help

 

tacr2man

Well-Known Member

• Jan 29, 2009

• #2

Sounds as if you have an airlock of somekind as the sachet should all go in a series swivel hub no probs

 

andyb66

Well-Known Member

• Jan 29, 2009

• #3

Spin the shaft, that should move the grease and hopefully the air lock.

Also worth putting the sachet of grease in hot water before you use it...makes the grease thinner.

 

jonteewilly

New Member

• Jan 29, 2009

• #4

erm,,"undone the four bolts on the top and took the cap off".thats not where the grease goes.there's a fill plug on the swivel side.

 

oil dripper

Well-Known Member

• Jan 29, 2009

• #5

jonteewilly said:

erm,,"undone the four bolts on the top and took the cap off".thats not where the grease goes.there's a fill plug on the swivel side.

Click to expand...

i was sayin tha ta Si earlier :hysterically_laughi

 

jonteewilly

New Member

• Jan 29, 2009

• #6

yeah hes been squeezin it thro an 1/8" hole in the railko,its a wonder he never dropped a plum doin it!

 

oil dripper

Well-Known Member

• Jan 29, 2009

• #7

jonteewilly said:

yeah hes been squeezin it thro an 1/8" hole in the railko,its a wonder he never dropped a plum doin it!

Click to expand...

good job nobody had done the penny trick on it cus he wudda bin fooked then

 

jonteewilly

New Member

• Jan 29, 2009

• #8

lol