S

Side-show-bob

Active Member

• Feb 2, 2012

• #1

Hi all

i am desperatly trying to replace the clutch on my 300tdi as i need it for the weekend, i have got as far as removing all the bell housing bolts and i can get about a 1/2" gap between the housing and the gearbox but no mater what i do it just wont come off...

Any ideas?

 

Dr_evil

Banned

• Feb 2, 2012

• #2

Gearbox mounts ?

 

S

Side-show-bob

Active Member

• Feb 2, 2012

• #3

Dr_evil said:

Gearbox mounts ?

Click to expand...

I have removed two thats all there are right? just checked the rave manual and it says to remove the chassie support and lower the gearbox, i am currently lowering it onto the supprot should i be lowering it lower to remove it?

 

Freelaner

Landy Driver

• Feb 2, 2012

• #4

Give it a good old waggle and pull at the same time it'll let go.


















Don't anybody edit this for accuracy.

 

Dr_evil

Banned

• Feb 2, 2012

• #5

Hoyt-Protec said:

Give it a good old waggle and pull at the same time………..and boom goes the dynamite



















Don't anybody edit this for accuracy.

Click to expand...

Who would edit it for accuracy ?

 

Freelaner

Landy Driver

• Feb 2, 2012

• #6

:doh:

 

jamesmartin

Well-Known Member

• Feb 2, 2012

• #7

if your doing it with transfer box on rear of boxes ned to be lowered to clear body and exhaust rear pipe ,use vehicle jack on panhard rod to hold front of engine up

 

GreenHornet

Well-Known Member

• Feb 2, 2012

• #8

i lowered the gearbox mount as well to make it easier. I know it sounds daft but if yiu havent lowered the box, how have yu got to the very top bolt? is the gap just at the bottom of the box as it sinks and pivots on the top bolt.