gardiner1

New Member
Hi can any one help i have just put range rover p38 seats in my 90 and wont to wirer the heated seats in. There are 4 wiers from each seat can i just put 12v or is it not that easey
cheers Richard:confused::alien:
 
The four wires are two pairs, one pair for the back and one pair for the base, the back and base are wired in series and there is a thermostat in the base other than that you will need a switch and fuse.
 
Hi can any one help i have just put range rover p38 seats in my 90 and wont to wirer the heated seats in. There are 4 wiers from each seat can i just put 12v or is it not that easey
cheers Richard:confused::alien:

This might be a bit late but, have you tested the heaters? These fail for a pastime with the elements breaking where the seat squab cushions flex. I'm asking because they're a lot easier to repair/replace with the seats out. A simple continuity test is all that's required.

When you do wire them in make sure that you wire the two elements for each seat in series otherwise you'll have a hotter ass than you expect, for a very short time anyway.

:D
 

Similar threads