J

Junder

New Member
Keep getting two faults on the hawkeye, 3007 ambient pressure low fault and 3039ambient pressure fault active I know these are to do with the sensor in the air box and have replaced the sensor twice but the faults won't clear, now at a loss as to what to do now, any ideas would be greatly appreciated
 
Junder said:
Keep getting two faults on the hawkeye, 3007 ambient pressure low fault and 3039ambient pressure fault active I know these are to do with the sensor in the air box and have replaced the sensor twice but the faults won't clear, now at a loss as to what to do now, any ideas would be greatly appreciated
Click to expand...

Check that the Ambient Air Sensor plug (the thingy attached to the clean air side of the airfilter housing, has a connector plug with three wires running from it) is plugged in ... and the sleeving / insulation is OK and not damaged ...
 
The faults appeared after i went wading, airbox was not as sealed as i thought and some water did get the airbox
 
Any ideas on the part number for the wiring loom that connects the sensor in the airbox, boost modulator etc (4 pin not 3 pin)
 
there's no separate loom for those...it's part of the main harness with all the other connectors...you have to identify the part number according to VIN to make sure...but you better check the wiring continuity cos it's expensive
 
Well only thing that has happened is that I went wading in deep water and got water in the airbox which has caused these faults so I am at a loss as to how to
Clear them
 
You must log in or register to reply here.

Similar threads

R
Manifold Pressure high logged 3030
2
Replies
24
Views
1K
sierrafery
sierrafery
Vagabondrobb
Disco 2 SLS again
Replies
9
Views
843
sierrafery
sierrafery
M
Front wheel speed sensor fault?
Replies
2
Views
466
Mid-life-crisis
M
Ashs1
D2 v8
Replies
11
Views
1K
sierrafery
sierrafery
W
AirCon Problems L320 4.4 petrol 2005
Replies
2
Views
54
Graculus
Graculus