James Active Member Mar 22, 2006 #1 I changed the glow plugs as there were a little worn. When I took them out 3 of the 4 they had oil on them. Should I be woried about this?
I changed the glow plugs as there were a little worn. When I took them out 3 of the 4 they had oil on them. Should I be woried about this?
S slob Well-Known Member Mar 22, 2006 #2 check yer haynes manual it should have little piccies showing what they should be like, and little piccies showing what they shouldn't be like
check yer haynes manual it should have little piccies showing what they should be like, and little piccies showing what they shouldn't be like
James Active Member Mar 22, 2006 #3 The ends were worn out but the shaft after the thread on the inside was coverd in engin oil.
helpme Active Member Mar 22, 2006 #4 don't worry about it mine are the same when you put your new ones in get a 3/8 drill bit and run it in the holes just to clean them up stop your new plugs shorting out
don't worry about it mine are the same when you put your new ones in get a 3/8 drill bit and run it in the holes just to clean them up stop your new plugs shorting out
