C

curzons246

New Member

• Jul 2, 2011

• #1

Hi all - I want to remove the front prop shaft to work on it, can I do this without removing the vcu and rear prop shaft, it's only about 1500 miles since it was all out to replace the VCU and it's bearings so it shouldn’t be to corroded?

 

freelance

Well-Known Member

• Jul 2, 2011

• #2

yes you can but i think you will find it easier to remove the lot and seperate on the bench.

 

C

curzons246

New Member

• Jul 3, 2011

• #3

Thanks Freelance I know what you say makes sense - it's just the thought of supporting the VCU with prop shafts attached whilst I fasten it up

 

R

rhodie

Active Member

• Jul 3, 2011

• #4

curzons246 said:

Thanks Freelance I know what you say makes sense - it's just the thought of supporting the VCU with prop shafts attached whilst I fasten it up

Click to expand...

use a freind or a jack

 

T

The Bodyman

New Member

• Jul 3, 2011

• #5

curzons246 said:

Thanks Freelance I know what you say makes sense - it's just the thought of supporting the VCU with prop shafts attached whilst I fasten it up

Click to expand...

Its best as a whole unit. Just done mine on my own. Its ok, just need to support the vcu with a jack or something.

Good luck