Hello I have a 2000 freelander 1 td4 its my 1st 4x4 and it’s a bit of fun, I have lifted it 50 mm to Give it more ground clearance looking to do the facelift mod I have the bumper and the lights as I only want to do the front I read a lot about plug-in and looms for the lights but can’t seem to find any anybody know where I can get them from? Or have a diagram so I can do that myself ?
Thank you

Oscarsurf said:

I read a lot about plug-in and looms for the lights but can’t seem to find any anybody know where I can get them from?

Click to expand...

I don't think anyone makes a plug in loom now. It's not difficult to make up something functional yourself as all the wiring colours match between old and new. The only difference is the facelift headlights keep the dip on when main is activated, whereas the pre-facelift turns the dip off when main beams are on. You can use a simple diode to join the dip to main wiring when mains are on. Be aware that this will load up the main beam circuit as it'll be feeding 4 bulbs instead of 2. But for short turm main beam usage, it should be ok.
I will at some point look into a better conversion as it comes up quite often.

Thank you very much forgetting back to me I will just get myself a multimeter and give it a go I didn’t know The ones with the same colours from years So that will help

diagram in cfaq section..... or was.

dont forget the relay and diode.

I will try and find it thank you