Birdbrain · Mar 31, 2023

I noticed one of my Defenders wheel nuts was missing yesterday! Don’t know if it’s been stolen or just worked loose. I can’t believe it’s worked loose as others are as tight as. Anyone know where I can get hold of a replacement? These came with a set of Modular’s that are quite old.

miktdish · Mar 31, 2023

That's a Defender wheel nut ???

lynall · Mar 31, 2023

miktdish said:
That's a Defender wheel nut ???

Aftermarket to match the wheels

BulletBrindle · Apr 5, 2023

https://www.wrington.co.uk/wheel-nuts-for-defender-with-steel-wheels/

I spotted those the other day when looking for stainless steel nuts...

tottot · Apr 5, 2023

The above may not fit those wheels as the nuts look to be of a smaller diameter for socket clearance of the flange cover cap thing. Without cap standard nuts should fit.

miktdish · Apr 5, 2023

BulletBrindle said:
https://www.wrington.co.uk/wheel-nuts-for-defender-with-steel-wheels/

I spotted those the other day when looking for stainless steel nuts...

The problem with stainless steel is it's soft (compared to std 8.8 HS nuts and very soft relative to 10.9 HS nuts).
There are several versions of stainless, some are harder than others but the one that approaches the hardness of 8.8 steel (A4-80) is difficult to cut. I asked Wrington what alloy they made thier nuts from and was told "it's not an alloy it's stainless steel" so I gave them a swerve.

Would you use Brass wheel nuts ?
IMO you should use a high tensile strength steel in critical locations (like holding your wheels on or your prop shafts) I'd suggest grade 10 (10.9) or 12.9 ...

dag019 · Apr 5, 2023

miktdish said:
That's a Defender wheel nut ???

I was thinking similar about the hub centre. None of it looks obviously defender!
It looks more along the lines of a dana 44 off a bronco or similar

BulletBrindle · Apr 6, 2023

miktdish said:
The problem with stainless steel is it's soft (compared to std 8.8 HS nuts and very soft relative to 10.9 HS nuts).
There are several versions of stainless, some are harder than others but the one that approaches the hardness of 8.8 steel (A4-80) is difficult to cut. I asked Wrington what alloy they made thier nuts from and was told "it's not an alloy it's stainless steel" so I gave them a swerve.

Would you use Brass wheel nuts ?
IMO you should use a high tensile strength steel in critical locations (like holding your wheels on or your prop shafts) I'd suggest grade 10 (10.9) or 12.9 ...

Yep, I appreciate that stainless steel is less strong when compared to HS steel, by maybe 50% depending on which blend (I ended up going for 316 from another supplier), but it's still many times stronger than it needs to be for the application.

However, the nuts from that supplier that look like the ones that the OP have are not stainless, as far as I can see.

Birdbrain

Well-Known Member

miktdish

Guns n Chainsaws

lynall

Well-Known Member

BulletBrindle

Active Member

tottot

Well-Known Member

miktdish

Guns n Chainsaws

dag019

Well-Known Member

BulletBrindle

Active Member

Similar threads