Hi guys
I am looking at modifying a 3.1/2.8 Isuzu flywheel to accept a LR clutch cover. Currently all conversion kits use the Isuzu cover with a Land Rover plate.

Does anyone have a land rover engine that would otherwise have been connected to an LT77 out of a vehicle which they could measure for me. The measurement I'm after is the distance from the face of the flywheel to the face of the engine that mates with the bell housing, i.e. How far is the flywheel recessed or protruding from the mating face.

Having run a slightly tuned 2.8 for years I think that the present isuzu clutch cover is working at it's limit and isn't fully compatible with the LR linkages for full movement.

Thanks in advance

Fred

Hi there Fred,
I know this question was asked a very long time ago now but I am looking for the same measurement. I don’t suppose there is any chance you ended up with a record of the answer at all? Many thanks.
Ryan

French75 said:

Hi there Fred,
I know this question was asked a very long time ago now but I am looking for the same measurement. I don’t suppose there is any chance you ended up with a record of the answer at all? Many thanks.
Ryan

Click to expand...

Not been on forum for a long time from his profile :-
freddynav was last seen:
Nov 21, 2014