StormAlpha

StormAlpha

New Member
Hi Guys,

Sorry for my limited knowledge, but i'm new to this....

Ive got a land rover 110 that was a TD5 but has had a 300 fitted....

and i want to fit a snorkel, so i ordered a Mantec and it arrived today, but shiws it fitting to a vent panel on the side of the wing...however i dont have that panel.

I only have a vent in the top of the left wing.....

am i able to retro fit this, or do i start again.

Thanking you in advance....

Storm
 
Thanks for the reply....

Ok ive just had a look at the wing and mine has the vent on the passengers side....

But the one i bought fits the drivers side...opppps!

So has mine got the wrong wing... i'm so confussed......

Storm
 
StormAlpha said:
Thanks for the reply....

Ok ive just had a look at the wing and mine has the vent on the passengers side....

But the one i bought fits the drivers side...opppps!

So has mine got the wrong wing... i'm so confussed......

Storm
Click to expand...

forget were you wing hole is were dose your air box pipe run to driver or passenger side like the one in pic the big round bake bean can shaped thing 9918.jpg
 
StormAlpha said:
Thanks for the reply....

Ok ive just had a look at the wing and mine has the vent on the passengers side....

But the one i bought fits the drivers side...opppps!

So has mine got the wrong wing... i'm so confussed......

Storm
Click to expand...

td5 intake is on drivers side wing passenger side intake is for the heater. are vents your talking about on top of the wing or on the side.
 
wickford90 said:
td5 intake is on drivers side wing passenger side intake is for the heater. are vents your talking about on top of the wing or on the side.
Click to expand...

I appreciate your help....

Ok, on the passengers wing there vent in the outer side wall and also a vent in the top of the wing as well.

On the drivers wing there is a styling type vent (Blank) on the top only....

?
 
StormAlpha said:
I appreciate your help....

Ok, on the passengers wing there vent in the outer side wall and also a vent in the top of the wing as well.

On the drivers wing there is a styling type vent (Blank) on the top only....

?
Click to expand...

it would seen you have not got td5 wings, seems strange to replace a td5 lump with a tdi. thought it would be easier to re-route air intake rather than replace BOTH wings, did you do the engine change.Does everything else on the vehicle all add up.
 
StormAlpha said:
I appreciate your help....

Ok, on the passengers wing there vent in the outer side wall and also a vent in the top of the wing as well.

On the drivers wing there is a styling type vent (Blank) on the top only....

?
Click to expand...

it sounds like someone has put older wings on it take some pics an post them an we can help you more (pics of wings an engine bay)
 
the original engine was a 2.5 Turbo Diesel 19J engine - as it's had an engine which usually vented on the opposite side I doubt you'll be able to buy one that fit without some messing about
 
StormAlpha said:
Cheers guys....

1990 LAND ROVER 110 300 TDI COUNTY on eBay (end time 08-Jun-11 19:10:50 BST)

This is it.....
Click to expand...
right first thing first its not a td5 there should be a pipe that comes off the air box/filter (underneath) about 3-4 inches thick see witch way it runs it will probably go to passenger wing side vent so ad say your better to buy a 200 tdi snorkel rather than fookin about an then it will just be a case of seal up an screw on save you trying to re-root pipes
 
You must log in or register to reply here.

Similar threads

D
Fitting a snorkel
Replies
19
Views
1K
drfoster
D
tweedandbriar
Fitting Van Sides
Replies
0
Views
233
tweedandbriar
tweedandbriar
R
Safari Snorkel
Replies
2
Views
641
KidYates
K
R
Southdown Snorkel Compatability
Replies
2
Views
355
RetroPug
R
H
Snorkel replacement?
Replies
10
Views
1K
Dr Strangeglove
D