hi guys could do with a bit of help just bought a ex military 110 with a knackered 2.5 na petrol in it want to put a 300 in it its got a lt77 box and i have whhole discovery 300 to steal mounts and bits off except gear box its a knackered auto if i take the flywheel housing off my 2.5na is it a straight forward job do i need to get mounts for engine out of disco and weld them or or is it all the same

i have a 200tdi 110 and a 300 110 and with the bocxes been different is it a problem
 
hi guys could do with a bit of help just bought a ex military 110 with a knackered 2.5 na petrol in it want to put a 300 in it its got a lt77 box and i have whhole discovery 300 to steal mounts and bits off except gear box its a knackered auto if i take the flywheel housing off my 2.5na is it a straight forward job do i need to get mounts for engine out of disco and weld them or or is it all the same
 
You will need to cut engine mounts off your chassis and move em forward if fitting a 300, I think..
 
Blood and obscenities also. I got lucky with oil pipes for my 200tdi swap. They swapped straight over, don't kno how common that is tho!
 
I have a 300tdi in mine with an LT77 as well. I didn't fit it myself but a mate did. The only issue I have is the rubber hose for the air filter fouls the bonnet so it a bit of a bodge. The LT77 does scream a little when you hit 60mph(ish) runs better at the 50mph.
There will be a load of room at the front because the 300tdi sits back further so you'll need to extend the hoses from the radiator and intercooler.
 
I have a 300tdi in mine with an LT77 as well. I didn't fit it myself but a mate did. The only issue I have is the rubber hose for the air filter fouls the bonnet so it a bit of a bodge. The LT77 does scream a little when you hit 60mph(ish) runs better at the 50mph.
There will be a load of room at the front because the 300tdi sits back further so you'll need to extend the hoses from the radiator and intercooler.


Ahh yeh, it's only if using the r380 gearbox you have to move the mounts I think..

Think the exhaust downpipe is a damn site easier then with a 200 conversion.
 
many thanks for that redhead im part way through it now just pulled engine out of both im going to give it a whirl next weekend fingers crossed should be ok not going to bother with power stearing and cant i just move rad oil cooler etc back and make brackets for it
 
many thanks for that redhead im part way through it now just pulled engine out of both im going to give it a whirl next weekend fingers crossed should be ok not going to bother with power stearing
I'd fit the PAS unless you've got arms like Arnie.
and cant i just move rad oil cooler etc back and make brackets for it

Rad is taller and the bonnet will strike the rad unless you lower the mounts.
 

Similar threads