The light on the 2x dash control switch goes on and off intermittently.
It's seems like a loose wire somewhere. When the light is out, the transfer
won't work. Any ideas out there? The vehicle is a 2000 GMC Jimmy.


Bye
Growl <growldeep-newsgroups@yahoo.ca> Sun, 29 May 2005 18:49:16 -0230

=== Posted with Qusnetsoft NewsReader 3.3

Hi, did you get your problem resolved? I have a 2000 GMC Envoy and the
light is switching between 2 and 4 wheel drive for awhile and now, I think
it is stuck on the 4 wheel drive mode... Is this the electronic module
(controller) problem? I can hear the solinoid kicking back and forth when
the light is switching.

My problem was fixed by removing the wiring harness plug from the transfer
case control module, cleaning a couple of corroded pins and plugging it
back in. The 4x4 has worked fine since them.


Reply to message from "afongofva" <afongofva@yahoo.com> (Mon, 20 Jun 2005
20:00:16) about "Re: Electronic transfer case.":

> Hi, did you get your problem resolved? I have a 2000 GMC Envoy and the
> light is switching between 2 and 4 wheel drive for awhile and now, I
> think it is stuck on the 4 wheel drive mode... Is this the electronic
> module (controller) problem? I can hear the solinoid kicking back and
> forth when the light is switching.




Bye
Growl <growldeep-newsgroup@yahoo.ca> Wed, 22 Jun 2005 18:55:38 -0230

=== Posted with Qusnetsoft NewsReader 3.3