whiperx
Member
Hi all,
So, I think I've sorted my overheating issue on my v6, however before I fixed all this it was throwing up a number of fault codes:
P0302 Cylinder 2 misfire
P1319 Misfire at low fuel level
P0131 O2 sensor circuit low voltage bank 1 sensor 1
P0107 Manifold absolute pressure/barometric pressure circuit low
Now, I haven't actually done anything directly to sort any of the above, just replaced various parts around the engine to fix the overheating issue. So I've cleared them.
Question though, I've started the engine and run it for a while, re-scanned and it's now showing no DTC's
Now, am I just lucky and everything I've done so far has fixed these previous faults OR do they not show up immediately? I thought they would come back pretty much as soon as the engine was started?
Thanks.
So, I think I've sorted my overheating issue on my v6, however before I fixed all this it was throwing up a number of fault codes:
P0302 Cylinder 2 misfire
P1319 Misfire at low fuel level
P0131 O2 sensor circuit low voltage bank 1 sensor 1
P0107 Manifold absolute pressure/barometric pressure circuit low
Now, I haven't actually done anything directly to sort any of the above, just replaced various parts around the engine to fix the overheating issue. So I've cleared them.
Question though, I've started the engine and run it for a while, re-scanned and it's now showing no DTC's
Now, am I just lucky and everything I've done so far has fixed these previous faults OR do they not show up immediately? I thought they would come back pretty much as soon as the engine was started?
Thanks.