Would much appreciate help with a clutch problem. The clutch on my vehicle was taking very low and at times could not engage first gear unless the clutch was pumped a few times. Bled the system same problem. Serviced the master cylinder with new seals and honed the inside of the barrel and refitted everything. Refilled with clutch fluid and did another bleed but cannot get the clutch to tighten up and take any earlier that before. Suspect air trapped somewhere but having no joy after trying various options.

Any help to solve this issue would be much appreciated.

Thanks

Iirc the clutch hyd damper could cause issues?
Flex hose?
Slave cylinder?

Hello and welcome

Welcome to the forum

This section is for introductions only. For technical help you should post your questions in the vehicle specific sections listed below, where owners of those vehicles will offer advice.

Main forum index:
https://www.landyzone.co.uk/forum

Freelander 1 and 2:
https://www.landyzone.co.uk/forum/land-rover-freelander.9

Defender, 90, 110, 130 (tratters)
https://www.landyzone.co.uk/forum/defender-90-110-130.7

Series 1, 2, 3 (tratters)
https://www.landyzone.co.uk/forum/series-land-rovers.6

Discovery:
https://www.landyzone.co.uk/forum/land-rover-discovery.8

Range Rover:
https://www.landyzone.co.uk/forum/range-rover.10