L

Lrt26

New Member

• Jan 22, 2012

• #1

I have a problem with my immobiliser

I'm not getting a switch live to the starter motor
I've been reading all sorts of things on what this could be and I was lead to believe it was the spider unit behind the heating controls but apon inspection I found I don't have one of these units can any one help cheers

 

robint

Well-Known Member

• Jan 22, 2012

• #2

you have edc then !! there is a way to bypass this i had it done on my old 300 by cant remember how to do it now

 

jamesmartin

Well-Known Member

• Jan 22, 2012

• #3

do you have a plastic box over pump solenoid or edc with wire on no4 injector and air flow meter in inlet pipe near filter

 

uncle albert

New Member

• Jan 22, 2012

• #4

check wiring loom o/s inner wing and through bulkhead, thats were they play up on 200s. I had to rewire whole ingition and starter when mine went somthing burnt out behind heater so bypassed and isolated fault

 

S

Steve_R1979

Active Member

• Jan 22, 2012

• #5

Could bypass the ignition switch and just use a press button to start it???

Would be MUCH easier than messing about with looms.

 

L

Lrt26

New Member

• Jan 22, 2012

• #6

Ive checked nearly the whole loom now,It looks ok also forgot to mention the red light for the alarm stays on all the time with the ignition on or off,

It' done my head in I've tried so many things but still nothing

 

jamesmartin

Well-Known Member

• Jan 22, 2012

• #7

which system is yours edc or box on pump

 

L

Lrt26

New Member

• Jan 22, 2012

• #8

I'm not 100 % sure how can you tell sorry not ha the Landy long so havent got to no it yet....

 

jamesmartin

Well-Known Member

• Jan 22, 2012

• #9

look at my earlier post