discodrivercumbria

Well-Known Member

• Sep 9, 2017

• #1

plastic wheel arch moulds and door moulds, 2 are as rough as a badgers arse, faided and discoloured, anybody painted them? just want satin black top coat, need primer etc to get them smooth, eat the sponge when i wash it, that rough!

 

Feathers McGraw

Well-Known Member

• Sep 9, 2017

• #2

Mine were like that on one side. Considered the filiing and painting route but ended up getting new ones a few weeks ago.

 

discodrivercumbria

Well-Known Member

• Sep 9, 2017

• #3

Feathers McGraw said:

Mine were like that on one side. Considered the filiing and painting route but ended up getting new ones a few weeks ago.

Click to expand...

how much for new?

 

brian47

Well-Known Member

• Sep 9, 2017

• #4

I have had some success with this stuff.
I just sanded the very rough surface off the whole trim part, cleaned it down with the degreaser spray then wiped the black stain over the part. If you just do a small piece it will work but the patch you treat will show up.
The odd little bits which I missed have remained grey but the bits which I treated have remained black.
Mask off the bodywork before you use the stain or it will show.

http://www.ebay.co.uk/itm/T-Cut-Bum...064765&hash=item5d5e4cdfc4:g:dcwAAOSwwbdWJmp6

 

sierrafery

Well-Known Member

• Sep 9, 2017

• #5

discodrivercumbria said:

.....eat the sponge when i wash it, that rough!

Click to expand...

I polished mines with a soft flexible pad then used this Amazon product cos it was available at a local supplier, i'm quite pleased with the result but mines were not as rough as you describe your's

 

Feathers McGraw

Well-Known Member

• Sep 10, 2017

• #6

discodrivercumbria said:

how much for new?

Click to expand...

Cannot remember exactly without checking back as I got a few other bits at the same time. Just over £260 at a guess.

 

steve's P38 RR

Active Member

• Sep 10, 2017

• #7

Rubbed mine down and they are actually pitted, so bear this in mind if you want a smooth painted finish. Going for rator finish on mine.

 

Feathers McGraw

Well-Known Member

• Sep 10, 2017

• #8

Feathers McGraw said:

Cannot remember exactly without checking back as I got a few other bits at the same time. Just over £260 at a guess.

Click to expand...

Found the invoice more like £296. Twice the price of pattern parts but I was worried about the fit and finish being right on none genuine bits.

 

discodrivercumbria

Well-Known Member

• Sep 10, 2017

• #9

i am going to remove them, front passenger wing is the worst, will see if i can get one off fleabay then paint them all, then re-mount them, taking plastic cills off too, waxoyl under and in then put back on,

 

Feathers McGraw

Well-Known Member

• Sep 11, 2017

• #10

Get the proper 3M trim tape to refit them.