Becks Bear

Active Member

• Jan 3, 2008

• #1

hi

will disco 200tdi front seats fit straight into my 90
if so do i need to any mods
will i be able to get at the battery if i fit disco seats

many thanks

 

yella

New Member

• Jan 3, 2008

• #2

no yes and maybe

 

GRUNT

Well-Known Member

• Jan 3, 2008

• #3

Ey yup Yella.

 

yella

New Member

• Jan 3, 2008

• #4

ello grunt, how yer doin mate

 

Pikey

Dummy Ejection Facilitator..

• Jan 3, 2008

• #5

Becks Bear said:

hi

will disco 200tdi front seats fit straight into my 90
if so do i need to any mods
will i be able to get at the battery if i fit disco seats

many thanks

Click to expand...

Question 2 dint make sense cos if the answer to Q1 is yes then the answer to Q2 is no and if the answer to Q1 is no then the answer to Q2 is yes. So it were pointless asking it in the first place.

 

oil dripper

Well-Known Member

• Jan 3, 2008

• #6

ya need sum steel box section to mek a subframe up to ya seatframe

 

bustersbus

Well-Known Member

• Jan 3, 2008

• #7

Why not use the rear seats?

 

Trewey

Cockernee, Pasty munchin bastid.

• Jan 3, 2008

• #8

or seats from a subaru imprezza -

 

busaboy

New Member

• Jan 3, 2008

• #9

Has the bulkhead been removed to get those in?

 

Becks Bear

Active Member

• Jan 3, 2008

• #10

busterbus
do the rear seats fit

as for the questions i have a disco which i am using as a donor vehicle and was hoping to use as many parts from it to improve my 90, thereby keeping my costs to a minimum

always remember there are no stupid questions and i have no doubt i will be asking for more advice, but many thanks for the input and the help

 

Pikey

Dummy Ejection Facilitator..

• Jan 3, 2008

• #11

busaboy said:

Has the bulkhead been removed to get those in?

Click to expand...

If you look at the gap between the seats you'll notice the bulkhead is still there. Or appears to be, unless he's stuck a sheet of ply in. Dont forget scooby seats are very thin.

 

bustersbus

Well-Known Member

• Jan 3, 2008

• #12

Becks Bear said:

busterbus
do the rear seats fit

as for the questions i have a disco which i am using as a donor vehicle and was hoping to use as many parts from it to improve my 90, thereby keeping my costs to a minimum

always remember there are no stupid questions and i have no doubt i will be asking for more advice, but many thanks for the input and the help

Click to expand...

Should do, Ah put range rover ones in mine

Have a look in me gallery or check out STEVES SITE

 

Trewey

Cockernee, Pasty munchin bastid.

• Jan 3, 2008

• #13

busaboy said:

Has the bulkhead been removed to get those in?

Click to expand...

I've got a MUD bulkhead removal bar fitted yes, but that's so that I can get the seats further back (I'm 6'4" and 16st). They would have fitted without this, but about 3" further forward.
The MUD bar is quite cheap (£99) and easy to fit, but only removes the top half of the bulkhead. However, that's all you need to move the seats back.

Incidentally, the fixings for the scooby seats are the same spacing as the LR ones, so they're a piece of **** to fit. I used some 1" box section so that I could get them a bit higher and further back.

 

busaboy

New Member

• Jan 3, 2008

• #14

I need to order a load of stuff from mudstuff, already fitted a dash thingy, good products.