Critical Mick
Member
I recently bought a Wild Bear wraparound rear diff guard. It came supplied with 2 M10 bolts to fasten one end to the existing holes in the underside of the diff but when I came to fit it the bolts were too wide. I tried an M8 but it was too loose. So does anyone know what the correct thread for these holes is, or are they actually M10 and just need a tap running in to clean them up?
I've nicked a picture from the internet and circled the holes I'm on about.
Thanks in advance for any light you can shed on this.
I've nicked a picture from the internet and circled the holes I'm on about.
Thanks in advance for any light you can shed on this.