I need to re-route the wires from the right knee switches to the Raptor centre console that I have fitted, as well as the stereo wires from the original mono radio position, or at least the aerial.

It seems that the best way is to pull them back through the bulkhead and then drill a grommeted hole back through behind the console for them to re-enter. Does this make sense? I do not do off-roading, just pull horses!!

I assume that they go into the knee-position switch bank from the engine compartment? If not, some practical suggestions would be welcome, as it is frying my otherwise decent brain!!

Thanks

They come from behind the speedo where the bulk of the wiring loom lives. Just stripped mine out completely and the wires all go through the very centre of the b/h except the heater motor and the brake light switch. You should be able to remove the speedo housing and pull them back up, then across to the centre.