discomania
Well-Known Member
Yes but you have have to take the turbo apart (two halves) and rotate the two halves so that the exhaust side meets up with your exhaust.
Remove the big circlip holding the ali housing onto the cast iron one. Separate them but take care not to damage the o-ring in between. Turn the ally housing approx. 90 degrees so it point upwards and assemble the two housings again.
The wastegate actuator needs to be moved, but this is only a matter of drilling and tapping a new set of bolt holes. Do it before you assemble the turbo...
Its easily enough done.
Remove the big circlip holding the ali housing onto the cast iron one. Separate them but take care not to damage the o-ring in between. Turn the ally housing approx. 90 degrees so it point upwards and assemble the two housings again.
The wastegate actuator needs to be moved, but this is only a matter of drilling and tapping a new set of bolt holes. Do it before you assemble the turbo...
Its easily enough done.
ratty
I'm not special I'm limited edition
yup.... :nopics: 
ratty
I'm not special I'm limited edition
yup.... :nopics:
you wanna 'discomania's how to on turbos' do you MHM?
:high5:
not personally - but it sounds like it would be a usefull "how to" fred to have - dont yu?
discomania
Well-Known Member
I am at work, I will post the pictures when I get in if I can find them.
ratty
I'm not special I'm limited edition
