G

gerwynstrange

Member
Any buying advice in particular about this year. Been fitted with a 300 tdi 80k from a different vehicle. Chassis seems ok, any particular places to look. Also anyone had experience putting a smaller steering wheel on, does it make much difference. How small can u go?[emoji12]
 
same as usual.

few differences. doors, wash/wipe, no side lights.. stuff like that.. nothing huge.

just make sure the engine is a good job and the chassis will have been welded or replaced
 
all of it. get underneath and bang the chassis with a hammer/screwdriver.

the rear xmember goes, so look up the legs a bit away from it to look for weld marks.

bulkhead rots around the footwells.

got any pics of it?
 
gerwynstrange said:
Any buying advice in particular about this year. Been fitted with a 300 tdi 80k from a different vehicle. Chassis seems ok, any particular places to look. Also anyone had experience putting a smaller steering wheel on, does it make much difference. How small can u go?[emoji12]
Click to expand...

1987, its a Ninety, or a One Ten, not a Defender.

Don't just look at the chassis, take a small hammer to it. rear xmember and rails, outriggers, where the upper rear xmember attaches to the top of chassis rails, especially go over the rear chassis legs going back to the rear xmember. Those are the worst area.

Bulkhead same, in the foot wells, on and around door pillars, under windscreen.

Why on earth would you want to put a small steering wheel on?standard wheel is well designed to control the vehicle on and off road!
 
Good advise I shall get hammering. I need a smaller wheel as me knees are far too high, the wheel is pushing against me legs. Looking to do tgat before rear bulkhead removal and seat rails. A small steering wheel then, does it adversely affect thibgs? More turning I guess but shes pas
 
if you can, get some pics of it up here before buying inside/outside/engine and underneath
 
gerwynstrange said:
Good advise I shall get hammering. I need a smaller wheel as me knees are far too high, the wheel is pushing against me legs. Looking to do tgat before rear bulkhead removal and seat rails. A small steering wheel then, does it adversely affect thibgs? More turning I guess but shes pas
Click to expand...

I would guess someone may have fitted a non standard seat, I am quite comfortable behind the wheel at 6 foot one, although the driving position isn't great for long journeys.

The standard wheel works well when you are picking your way through rocky sections, and hanging out the window to see where the front wheel is.

No experience of a small wheel, I think the later Td5s and so on may have them, but never had one.

And like trax says^^^^^^^^^^^^, post some pics of it, and you will get a few frank opinions about it :)
 
I ran a 300mm Raid wheel on my 1986 90 for years, suited me perfectly, am now on a 350mm Momo. Just fancied a slightly different style and it didn't take long to get used to the (slightly) larger diameter.
Both are significantly smaller than the original offering which was not required after I had retrofitted PAS.
 
gerwynstrange said:
Heres the link with loads of pics but no chassis pics


Cheers
Click to expand...

Been cleaned and painted up for the forecourt, some cheap mods on it! :rolleyes:

To be fair,good looking wheels and tyres, and the engine bay looks pretty well cared for! :)

Shame there are no pics of the underside, or any of the problem areas of the bulkhead. What very little of the mechanics and chassis can be seen looks a little dry and unprotected. Check the chassis and bulkhead carefully, would be my top tip on that one.
 
loads of parts swapped. not orig roof, doors, wings, grill, inside.

orig steering wheel and maybe dash.

crap conversion on the interior.. whats with the auto stick.. can see rust on the bulkhead.

i'd walk away if it was me, not worth the money... if it's really a 1987
 
Last edited:
trax said:
loads of parts swapped. not orig roof, doors, wings, grill, inside.

orig steering wheel and maybe dash.

crap conversion on the interior.. whats with the auto stick.. can see rust on the bulkhead.

i'd walk away if it was me, not worth the money... if it's really a 1987
Click to expand...

+1 Forgot, interior is crap! :(

What we used to call a bitsa, bits of everything! ;) :D
 
Looks a tarted up vehicle that has has got bodger all over it , signs of poor repairs to bulkhead etc etc way overpriced JMHO
 
just to be clear, i'd have bought the other fender just not for that price ;)

give him 1500 :D
 
You must log in or register to reply here.

Similar threads

Scumball500
1987 defender wing
Replies
6
Views
364
Knappster
Knappster
G
Defender 90 advice
2
Replies
30
Views
1K
grandy21
G
vizsla
Diesel heater
Replies
2
Views
314
Rougharse Racing
Rougharse Racing
K
Defender 110 TDI 300 For West Africa Trip
2
Replies
21
Views
2K
shaynecm
S
J
New member Mid Wales
Replies
18
Views
978
JohnKaye
J